Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning and Maintenance
FOR BEST SHAVING PERFORMANCE
We recommend that you use your
new shaver daily for two to three
weeks to allow time to find an opti-
mum shaving method for your par-
ticular type of hair-growth patterns.
NOTE: In case of accidental separa-
tion of shaver head: To reattach
head, hold on the fully open position,
direct one of the two hinges pins
on the shaver into corresponding
slotted hole on the head assembly,
then swing the opposite hinge pin
into place.
For assistance or help, call our
customer service at 800-736-4648
in the U.S. or 800-268-0425 in
Canada.
8
32638_WDF-3500_5500_6000_7000_IB.indd 8-9
Battery Removal
When your rechargeable shaver
reaches the end of its useful life and
before throwing away the shaver,,
the batteries must be removed and
recycled or disposed of properly in
accordance with your state and local
requirements.
Caution: Dispose of batteries proper-
ly in accordance with your local and
state requirements. Do not put in fire
or mutilate your batteries when dis-
posing, as they may burst or release
toxic materials. Do not short-circuit
as it may cause burns.
The EPA-certified RBRC
Battery
®
Recycling Seal on the nickel-cad-
mium (Ni-Cd) battery indicates
Spectrum Brands, Inc. is voluntarily
participating in an industry program
to collect and recycle these batteries
at the end of their useful life, when
taken out of service in the United
States or Canada. The RBRC
pro-
®
gram provides a convenient alterna-
tive to placing used Ni-Cd batteries
into the trash or the municipal waste
stream, which may be illegal in your
area. Please call 1-800-8-BATTERY
SM
for information on Ni-Cd battery
recycling and disposal bans/ restric-
tion in your area. Spectrum Brands,
Inc.'s involvement in this program is
part of our commitment to preserv-
ing our environment and conserving
our natural resources.
For disposal of shaver, how to
Remove the Battery:
1. Press the head release button to
open the shaver's head assembly.
2. Pull the cutters off the cutter drivers
that hold them.
3. Use a Phillips head screwdriver to
remove the four (4) screws that
hold the head assembly in place.
4. Lift the head assembly out of the
shaver by grasping the cutter and
trimmer drivers, lining them up in
the central position, and pulling.
Discard.
5. Remove the next four (4) screws, so
you can lift the shaver's upper outer
shell off the shaver and discard it.
6. Grasp the inner assembly and twist
it counterclockwise to unlatch it
from the shaver's lower outer shell.
Lift it out, and discard everything
else.
7. Cut the tape holding the motor to
the inner assembly, and discard it.
8. Cut the large rubber gasket from
the inner assembly, and discard it.
9. Separate the two (2) inner shell
halves to expose the PC board and
battery assembly.
10.Cut the two (2) metal tabs
connecting the batteries to the PC
board.
11.Pull the batteries free from the
adhesive tape, and dispose of
properly.
3
2
4
1
5
7
6
9
9
10
8
9
2/22/07 12:57:09 PM
Publicité
Table des Matières
