Battery Removal - Remington R-9170 Guide D'utilisation Et D'entretien

Charging
Prior to using your shaver for the first time, put it on
charge for 24 hours.
To charge your shaver:
Make sure your shaver is turned off.
Connect the cord to the shaver and then the charging
adapter to the electric outlet.A charging indicator
light will come on.
Your shaver cannot be overcharged,so you can leave
it plugged in and charging between shaves.
Use only the charging adapter supplied with the
s h av e r.
Special feature allows you to run the shaver directly
off the cord. Your shaver will not recharge while you
are shaving,so after shaving directly from the cord,
turn the unit off and set aside to charge.
Provides up to two weeks worth of shaving after a
one hour charge or a single shave after five minutes
of charging.
Model R-9170
A green indicator light shows whether the shaver is
either fully charged or chargi n g . A red low-bat t e ry indicat o r
illuminates to show when the shaver needs rechargi n g .
This also indicates ap p r o x i m at e ly 5 minutes of shaving
time left when indicator first comes on.
Model R-9270
A green lighted fuel gauge displays the amount of charge
remaining in 20% increments.When only 20% of the
charge remains, the recharge red warning light illuminat e s .
Model R-9370
An LCD display numeric indicator shows shaver charge
status in minutes remaining.When the plug icon
comes on,it indicates approximately 5 to 6
minutes of shaving time left.
Troubleshooting:
If your R-9170/9270/9370 shaver battery is completely dis-
charged or the shaver has not been used for an extended period
of time,the shaver may not start when operated using the cord.
If this condition occurs, charge the shaver for ap p r o x i m at e ly
five minutes before shaving.
Your cord/cordless shaver should not be used strictly as a
cord-operated shaver, as continued cord only use will result in
reduction of battery life.
In order to preserve the life of the batteries,they should be fully
discharged every six months and then fully charged for 24
hours.
Worldwide Voltage (all MicroFlex ®
You can take your shaver with you when you travel to just about
anywhere in the world. Your shaver features worldwide automatic
dual voltage conversion providing AC current between 100-240
volts AC,50-60 Hz.Just plug it in to the local outlet (you may
need an adapter plug) and use as usual. Your shaver will convert
a u t o m at i c a l ly to the local current requirements.

Battery Removal:

When your rechargeable shaver reaches the end of its useful life,
the batteries must be removed from the shaver and be recycled
or disposed of properly in accordance with your state and local
requirements.
THE FOLLOWING PROCEDURE SHOULD BE FOLLOWED
FOR BATTERY REMOVAL:
To avoid a possible electric shock hazard,
unplug cord from electric outlet and shaver.
Open the head assembly by pressing the
head release buttons and lifting the head
assembly. Pull the entire head assembly off
of the shaver assembly.
Push the trimmer button up to open the trimmer.
Remove the trimmer assembly by squeezing
the sides as shown in the picture.
Using a small Phillips head screwdriver,
remove the 3 screws from the back of the
s h av e r.
Pull or gently pry the shaver halves apart,
exposing the battery.
Pry the lower battery clip off.
Lift or pry the batteries out of the shaver.
models)
Cut the wires on both ends of each battery
and remove them from the shaver.
CAUTION:DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES WHEN
DISPOSING AS THEY M AY BURST OR RELEASE TOXIC MAT E R I A L S .D O
NOT SHORT CIRCUIT AS IT MAY CAUSE BURNS.DISPOSE PROPERLY
IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS.
The EPA certified RBRC
cadmium (Ni-Cd) battery indicates Remington Products Company,
L.L.C.is voluntarily participating in an industry program to collect
and recycle these batteries at the end of their useful life,when taken
out of service in the United States or Canada. The RBRC
provides a convenient alternative to placing used Ni-Cd b atteries
into the trash or the municipal waste stream, which may be illegal in
your area. Please call 1-800-8-BAT T E RY
b at t e ry recycling and disposal bans/restriction in your area.Remington
Products Company, L.L.C.'s involvement in this program is part of our
commitment to preserving our environment and conserving our natural
resources.
® Battery Recycling Seal on the nickel-
® program
S M
for i n fo r m ation on Ni-Cd