Horizon Fitness CT9.1 Manuel Du Propriétaire page 3

SPEAKERS
WATER BOTTLE HOLDER
GRIP PULSE HANDRAILS
SPEED/INCLINE TOGGLES
CAUTION AVERTISSEMENT PRECAUCIÓN
KEEP HANDS AND FEET GARDER LES MAINS ET LES MANTENGA LAS MANOS Y
AWAY FROM THIS AREA. PIEDS LOIN DE CETTE REGION. LOS PIES LEJOS DE ESTA
HIGH-PRESSURE LES AMORTISSEURS À HAUTE AREA. IMPACTOS DE ALTA
SHOCKS COULD CAUSE PRESSION PEUVENT CAUSER PRESIÓN PUEDEN CAUSAR
BODILY INJURY. DES BLESSURES. DAÑO CORPORAL.
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
1 TRANSPORT WHEEL
2
WHEEL LOCK
1 2
ABOVE FOOT LATCH
4
CT9.1-OM-rev1.3.indd 4-5
TooLS inCLUDED:
F 6 mm T-Wrench
TOUCH PAD PANEL AND DISPLAY WINDOWS
F 5 mm T-Wrench
F Screwdriver
CONSOLE
PArTS inCLUDED:
F 1 Console Assembly
F 2 Console Masts
SAFETY KEY PLACEMENT
F 2 Console Mast Caps
F 2 Console Mast Boots
CONSOLE MAST
F 2 Main Frame Boots
F 4 Hardware Bags
MOTOR COVER
F 1 Safety Key
F 1 Power Cord
FOOT LOCK LATCH (UNDERNEATH DECK) F 1 Audio Adapter Cable
F 1 Bottle of Silicone Lubricant
RUNNING BELT / RUNNING DECK
SIDE RAIL
ROLLER END CAP
REAR ROLLER
ADJUSTMENT BOLTS
CAUTION AVERTISSEMENT PRECAUCIÓN
KEEP HANDS AND FEET GARDER LES MAINS ET LES MANTENGA LAS MANOS Y LOS
AWAY FROM THIS AREA. PIEDS LOIN DE CETTE REGION. PIES LEJOS DE ESTA AREA.
PrE ASSEMBLY
UnPACKinG
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Never open box when it is on its side. Once the banding straps have been removed,
do not lift or transport this unit unless it is fully assembled and in the upright folded
position, with the lock latch secure. Unpack the unit where it will be used. The enclosed
treadmill is equipped with high-pressure shocks and may spring open if mishandled.
Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill.
WArninG
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
(for 2 applications)
WArninG
nEED HELP?
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
If you have questions or if
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
there are any missing parts,
partially threaded in before completely tightening any ONE bolt.
contact Customer Tech
Support. Contact information
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
is located on the back panel
such as lithium bike grease is recommended.
of this manual.
5
9/3/09 3:54 PM