Rcf Bm 3001 / Bm 3003 Paging Microphones - RCF Invision 354MP Manuel De L'utilisateur

4 DIP-SWITCH GROUP (PER EACH CHANNEL 1÷4)
For each channel, it is possible to set the input gain (with or without PHANTOM power supply) on/off,
insert / remove the high-pass filter and enable / disable the chime, which is played on every priority
event.
INFORMATION ABOUT THE CHIME
The chime is not played when using the channel 1 VOX function (a priority command is needed to
play the chime).
Its melody can be either short or long (dip-switch 7 of the PRESET group
SHORT
When the chime is playing (a few seconds), in the single mode operation, the music (internal or
external through the AUX INPUT) is muted.
SETTING AUTOMATIC STORE
All settings by the front panel buttons are automatically stored after 10 seconds since the last button
pressure.
If a priority event is in progress, it is possible to change the state of each single button (by pressing
it), but the respective effect will be actually applied and stored only when the priority event ends.

RCF BM 3001 / BM 3003 PAGING MICROPHONES

Channels 2 and 3 have an input with RJ 45 socket, to which it is possible to connect 2 models of RCF
paging microphones (not included):
•
BM 3001 (for all calls only)
•
BM 3003 (for 3-zone selective calls and 'daisy-chain' links of up to 12 paging microphones in
the same line).
Only one BM 3001 paging microphone can be connected to each RJ 45 input (max. 2: one to the
input 2, one to the input 3).
The BM 3001 operating mode and its priority depends on settings previously described.
i
It is possible to assign the SMART function to each BM3001 paging microphone through the
dip-switches 5 (for the input 2) and 6 (for the input 3) of the PRESET group
D
.
LONG
D
.
53