RCF Invision 354MP Manuel De L'utilisateur page 43

A
PAGING OUT audio output (with RCA connector)
It sends either the mix of the channels 1, 2, 3, 4 (with no priority events in progress) or the only
input (1 ÷ 4) with priority or the chime (triggered by any priority command, if enabled) or the
tone set for the SEQUENTIAL COMMAND
Use this output to connect the additional amplifier (if this is assigned for paging and/or the mix
of inputs 1÷4).
6
The MASTER volume and the remote one (if connected to REMOTE CONTROL MASTER
J
) do not affect this output.
i
Input 1 ÷ 4 signal levels depend on the respective channel volumes
depends on the CHIME LEVEL
S
MUSIC OUT audio output (with RCA connector)
It sends the audio signal of the selected music source (internal CD/USB – MP3 player and tuner,
o
AUX INPUT , off).
The level depends on both the internal player/ tuner (or the AUX
i
GAIN control on the rear panel when selecting the AUX INPUT) and the remote control
potentiometer (if connected to REMOTE CONTROL BGM
Use this output to connect the additional amplifier (if this is assigned for the music).
D
12 dip-switches PRESET (system / priority options):
IN 1 –
1.
PAGING A B C TO
IN 4
IN 4 NORMAL –
2.
IN 4 OVERRIDE
INTERLOCKED –
3.
GRAD. PRIOR.
1/2-3/4
OFF –
4.
VOX ON INPUT 1
OFF –
5.
SMART INPUT 2
OFF –
6.
SMART INPUT 3
G
.
F
control on the rear panel; the siren level is fixed.
IN 1: the 3 PAGING zone selection
buttons (on the front panel) are assigned
to the channel 1.
IN 4 NORMAL: the channel 4 volume is
}
affected by the attenuators during
its priority.
INTERLOCKED: interlocked priority mode
OFF: the channel 1 VOX function is off.
OFF: the channel 2 priority is held only
if the relevant command is still present
('push' mode). Note: set to OFF if 1 or
more BM 3003 paging microphones
are connected to the input 2.
OFF: the channel 3 priority is held only
if the relevant command is still present
('push' mode). Note: set to OFF if 1 or
more BM 3003 paging microphones
are connected to the input 3.
1
, the chime level
2
volume and its respective
J
).
PAGING A B C TO IN 4: the 3 PAGING
zone selection buttons (on the front panel)
are assigned to the channel 4.
IN 4 OVERRIDE: the channel 4 volume is
}
not affected by the attenuators
its priority.
GRADUATED PRIORITY 1/2–3/4:
graduated priority mode
VOX ON INPUT 1: the channel 1 VOX
function is on (automatic priority when a
signal is detected on the audio INPUT 1).
SMART INPUT 2: the channel 2 priority is
switched on / off by every impulse of the
relevant command ('toggle' mode).
SMART INPUT 3: the channel 3 priority is
switched on / off by every impulse of the
relevant command ('toggle' mode).
during
43