RCF Invision 354MP Manuel De L'utilisateur page 48

As soon as a priority event ends, the initial state will be restored (the channels 1, 2, 3, 4 and the
selected music source will be mixed together, unless another priority event is in progress).
About selective paging to A, B, C zones (separated ZONE OUTPUTS
•
The state of front panel PAGING
•
The setting of the dip-switches 1 and 2 PRESET
•
The device requiring the priority (for instance, BM 3001 paging microphones can make general
calls only, BM 3003 can make selective calls).
}
The 3 zone attenuators can adjust the level on the separate 70 V / 100 V ZONE OUTPUTS
:
but the DIRECT OUTPUTS
these controls.
The audio signal of an event with priority and 'override' is always sent to the separate outputs with
its. max. set volume, without being controlled by the zone attenuators.
The audio signal level of an event with normal priority is also adjusted by the zone attenuators.
i
OVERRIDE' means that audio signals are sent without being affected by the 3 zone
}
attenuators .
THE 3-ZONE SELECTIVE PAGING IS CONTROLLED ACCORDING TO THE FOLLOWING RULES:
1. 9
If the GENERAL button
paging microphone, paging will be general ('all call') in the OVERRIDE mode (regardless of any
other setting).
2.
When the priority is got by the channels 2 – 3 (or by a BM 3001 paging microphones connected
to either the input 2 or 3) or the SEQUENTIAL COMMAND
general ('all call') in the OVERRIDE mode (regardless of any other setting).
3.
From BM 3003 paging microphone (connected to the inputs 2 and 3), users can always select
the zones to be paged (OVERRIDE mode).
4.
When the priority is got by the channel 1, paging will be always in the OVERRIDE mode; the zone
selection depends on both the dip-switch 1 of the PRESET group
P
buttons :
•
If the DIP 1 is set to 'PAGING A B C TO IN 4', paging is always general (regardless of the
PAGING button selection).
•
If the DIP 1 is set to 'IN 1', paging is selective to the zones chosen through the PAGING
buttons (note: if no zone is selected, paging is only sent to the DIRECT OUTPUTS
5.
When the priority is got by the channel 4, paging can be either normal or in the OVERRIDE mode,
according to the dip-switch 2 setting of the PRESET group
9
button ). The zone selection depends on both the dip-switch 1 (PRESET group
front panel PAGING buttons
•
If the DIP 1 is set to 'IN 1', paging is always general (regardless of the PAGING button
selection).
•
If the DIP 1 is set to 'PAGING A B C TO IN 4', paging is selective to the zones chosen
through the PAGING buttons (note: if no zone is selected, paging is only sent to the DIRECT
:
OUTPUTS ).
48
P 9
and GENERAL
D
on the rear panel.
(and the additional external amplifier, if present) are not affected by
is on, when the priority is got by one of the channels 1 ÷ 4 or a BM3001
P
:
L
), it is necessary to consider:
buttons.
G
, paging (/ the alarm tone) will be
D
and the front panel PAGING
D
(and also the front panel GENERAL
D
L
,
:
).
) and the