Priority - RCF Invision 354MP Manuel De L'utilisateur

PROCEED AS FOLLOWS:
a.
Ensure the dip-switches 9 and 10 PRESET
b.
Ensure the dip-switches 11 and 12 PRESET
c.
Adjust (momentarily) the MASTER
d.
Choose a music source (internal or AUX IN) through the front panel buttons
e.
Select zones where to send the music through the 3 MUSIC
f.
Adjust the music volume (through either the CD/USB – MP3 player and tuner volume or the AUX
2
IN control).
g.
If loudspeakers are connected to the ZONE OUTPUTS
to MAX. (not necessary when using DIRECT OUTPUTS
h.
Adjust the MASTER volume to get the desired level.
i.
If necessary, attenuate the output level of each zone by using its respective attenuator
j.
Adjust the channel 1 ÷ 4 volumes
i
Note: here above it is assumed that remote control potentiometers are not connected or, if
connected, these are temporarily set to their max. level.

PRIORITY

THE PRIORITY COMMAND IS GOT:
•
Through channels 1 ÷ 4, by connecting (in the removable connectors
contact CMD to ground (GND); the priority remains activated if the link is stable (but the input
2 and 3 SMART function).
•
By the channel 1 through its VOX function (if enabled).
•
Through BM 3003 / BM3001 paging microphones connected to the 'RJ' port
2 and 3, considering that removable connectors (for priority commands and audio signals)
cannot be used if lines are engaged (in order to avoid malfunction).
•
By the SEQUENTIAL COMMAND
If any priority command is in progress (including VOX), only the channel with priority (among inputs
1 ÷ 4, BM 3003 / BM 3001 paging microphones, SEQUENTIAL COMMAND) is sent to the DIRECT
:
OUTPUTS for loudspeakers.
The selected music source and the other inputs are muted (even on ZONE OUTPUTS
When a priority event is in progress, the 'PRIOR' LED
[
OUT only includes the channel with priority.
THE PRIORITY MODE (INCLUDING THE VOX FUNCTION) IS SET BY THE DIP-SWITCH 3 PRESET
DIP 3 MODE
INTERLOCKED INTERLOCKED
GRAD. PRIOR.
GRADUATED PRIORITY
1/2-3/4
G
are both set to OFF (or both set to ON).
G
are both set to ON.
6
control at (circa) half volume.
{
L
, temporarily set the 3 attenuators
:
).
1
if these inputs are connected.
G
.
7
gets lit and the audio signal sent to the PRE
Only the first priority command of channels 1 ÷ 4 is accepted (also channel 1 VOX, if
enabled through the dip-switch 4 PRESET
accepted until the previous one is removed.
Note: the only event that can always be activated later (and overrides a previous priority)
is the SEQUENTIAL COMMAND
A priority command having a higher level can override the previous one.
The priority levels are:
1. (highest) SEQUENTIAL COMMAND
2. channel 1 (including VOX)
3. channels 2 and 3 (interlocked each other)
4. channel 4
3 4
;
buttons.
}
.
e
) the respective
q
of the channels
L
).
D
D
). Any other priority command will not be
G
.
47
}
: