Télécharger Imprimer la page

BH FITNESS G6463 Instructions De Montage Et Utilisation page 20

Masquer les pouces Voir aussi pour G6463:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
EXERCISE PROGRAM.-
Before starting any exercise program,
bearing
in
mind
programs vary depending on age and
physical condition, it is advisable to
consult your doctor given that you will
achieve
better
his/her
advice
Regardless of whether your goal is to
become fitter, control your weight or
for physiotherapy, always remember
that your exercise should be gradual,
planned,
varied
demanding. We recommend that you
should exercise 3 to 5 times per week.
Before beginning a session it is
important to do a warm-up for 2-3
minutes at low speed. This will help
protect your muscles and prepare your
cardiorespiratory system.
The next stage will last 15-20 minutes
at a pulse rate of between 65 to 75%,
or between 75 to 85% for those
already accustomed to exercise. At a
later stage, once we have become
fitter, we can divide this time between
both levels but always remembering
that the pulse rate must not exceed
85% (aerobic area) and never reach
the maximum heart rate limit that
corresponds to our age.
We you have finished, it is important
to relax the muscles. This can be done
by walking at a low speed for 2-3
that
exercise
results
based
or
suggestions.
and
not
minutes until the heart rate drops
below the 65% line. This will prevent
muscle
intense session. It is also advisable to
finish
relaxation exercises on the floor.
FINAL NOTE
We hope that you enjoy your unit. You
will soon notice the benefits of your
controlled exercise program, you will
feel better, have more energy and
suffer less stress.
INSPECTION & MAINTENANCE.-
Switch the unit off and unplug the
mains cable.
Use a damp cloth or towel to clean the
on
dust off the treadmill, especially the
side bars and the electronic console.
Do not use solvents.
Use a vacuum cleaner to carefully
vacuum
components (belt, structure, etc.). You
too
can also vacuum the underside of the
unit by resting it on one of its sides.
Similarly, you can vacuum the inside
of the motor housing by removing the
cover that protects the motor (be
careful with the wires).
ATTENTION:
Periodically check that all of the
fastening
tightened and connected correctly.
Check and tighten all the parts on
your unit every three months.
Use of this machine with worn parts,
e.g. the drive belt, running belt or
rollers, may cause the user injury.
When in doubt about any parts on the
machine, do not hesitate to get in
touch with the Technical Assistance
Service by phoning customer services
(see last page in manual).
20
pain,
especially
the
program
around
elements
after
an
with
some
the
visible
are
duly

Publicité

loading