Changing The Color Of The Actuator Caps; Commissioning; Maintenance, Overhaul, Repair; Maintenance - Stahl PanSiC 8018/3 Série Mode D'emploi

5.3

Changing the Color of the Actuator Caps

▶
Insert a flat screwdriver between the button and the coloured filter disk and lever the
coloured filter disk out of its anchoring.
▶
Remove coloured filter disk.
▶
Snap in a new coloured filter disk.
6

Commissioning

Before commissioning, carry out the following checks:
▶
Check the enclosure for damage.
▶
Check that mounting and installation have been performed correctly.
▶
Remove any foreign objects.
▶
If necessary, clean the connection chamber.
▶
Check whether all the specified tightening torques have been observed.
7

Maintenance, Overhaul, Repair

▶
Observe the relevant national standards and regulations in the country of use.
7.1

Maintenance

Check the following points in addition to the national regulations:
• Whether the clamping screws holding the electrical lines fit securely
• Whether the device enclosure and/or protective enclosure has/have cracks or other visible
signs of damage
• Whether the permissible temperatures are complied with
• Whether the parts are securely fitted
• Ensure it is being used as intended.
7.2

Overhaul

▶
Perform overhaul of the device according to the applicable national regulations and the
safety notes in these operating instructions ("Safety" chapter).
▶
The only overhaul measure is a periodic inspection for damage and proper operation.
7.3

Repair

▶
Repair work on the device must be performed only by R. STAHL.
▶
Any damaged parts of the device or a damaged device must be replaced promptly to
ensure the electrical safety and explosion protection of the system.
290432 / 8018607300
2021-06-11·IO00·III·en·00
LED illuminated pushbutton
for panel mounting
Series 8018/3
Commissioning
DE
US
FR
IT
ES
RU
NL
DK
11465E00
SE
FI
PT
GR
PL
CZ
SK
HU
SL
RO
BG
LV
LT
EE
CH
KR
CN
9