Grizzly ERV 1201-31 ZV Set Traduction De La Notice D'utilisation Originale page 51

toes. While working always
keep your feet and fingers well
away from the cutting cylinder
and the ejector opening. There
is the danger of serious injury!
• Do not operate the imple-
ment while it is raining, in poor
weather conditions and when
the surrounding area and lawn
are wet. Operate the implement
only during daylight hours or
with bright lighting. There is a
risk of accidents.
• Do not operate the implement
if you are tired or are lacking in
concentration and after having
drunk alcohol or taken medi-
cine. Always take a work break
in due time. Approach the work
with common sense. A moment
of carelessness when using the
equipment can result in serious
injury.
• Familiarize yourself with the
terrain and remain focused on
the potential hazards that you
could miss on account of the
motor noise.
• Always maintain a secure foot-
ing while working, especially on
a sloping terrain. Always work
across slopes - never up and
down! Be particularly careful
when changing the travelling
direction. Do not work on very
steep slopes. This enables you
to control the equipment better
in unexpected situations.
• Always guide the implement
at a walking pace with both
hands on the handle. Be es-
pecially careful when you turn
the implement around or draw
it towards you. Danger of stum-
bling!
• Start or actuate the starting
lever with care and in conform-
ity with the directions in these
Instructions.
• Do not tilt the implement when
starting, other than it has to be
lifted. In this case tilt the imple-
ment only to the extent that
is absolutely necessary and
always lift the implement on
the side that is opposite to the
operator.
• Never operate the implement
without the attached collection
bag or impact protector. Dan-
ger of injury! Always keep well
away from the ejector opening.
• Do not operate the implement
in the vicinity of inflammable
liquids or gases as this could
give rise to the danger of a fire
or explosion.
• Always disconnect the plug
from the mains socket before
working.
Work intervals:
• After the implement has been
turned off, the cutting cylinder
will continue to rotate for a few
seconds. Keep hands and feet
well away.
• Do not touch the spring tines
before the implement has been
disconnected from the mains
and the spring tines have come
to a complete standstill. Risk of
injury owing to a sharp imple-
ment!
• Only remove plant parts when
the implement is standing com-
pletely still. Ensure that the
grass ejector opening is clean
GB
51