Kenwood MAJOR PRO KMP770 Série Mode D'emploi page 7

troubleshooting
problem
The whisk or K-beater knocks against the bottom of the bowl or isn't
G
reaching the ingredients in the bottom of the bowl.
solution Adjust the height. Here's how:
G
Unplug the appliance.
1
Raise the mixer head and insert the whisk or beater.
2
Lower the mixer head. If the clearance needs to be adjusted, raise the
3
mixer head and remove the tool.
Using a spanner loosen the nut
4
shaft . To lower the tool closer to the bottom of the bowl, turn the
beater shaft anti-clockwise. To raise the tool away from the bottom of the
bowl turn the shaft clockwise.
Re-tighten the nut.
5
Fit the tool to the mixer and lower the mixer head. For best performance
6
the whisk or K-beater should be almost touching the bottom of the
bowl .
Repeat the above steps as necessary until the tool is set correctly. Once
7
this is acheived tighten the nut securely.
flexible beater Ideally the flexible beater should be almost touching the bottom of the
bowl but ensure that the flexible beater wing is not bent against the bowl
base as this will cause excessive wear. If necessary adjust as detailed
above.
problem
The mixer stops during operation.
G
solution Your mixer is fitted with an overload protection device and will stop if
G
overloaded to protect the machine. If this happens, switch off and
unplug the mixer. Remove some of the ingredients to reduce the load,
and allow the mixer to stand for a few minutes. Plug in and press the
start button. If the mixer does not restart immediately allow to stand for
additional time to allow the mixer to cool down.
sufficiently to allow adjustment of the
5