SUHNER LWC 17-45 DH Instructions D'utilisation page 4

Technical Data LWC 17-45° DH
at 90 PSI Operating Pressure
Power
Torque
Air consumption
full load
Air consumption
no load
No load speed
Sound pressure level
ISO 15744
Vibration according
ISO 8662
weight without hose
Recommended air quality
accord. DIN ISO 8573-1
Air hose ID
Collets
(refer to APT catalog)
Machine components
1 Right angle gear head
2 Safety lever throttle
3 Valve handle
4 Spindle
5 Wrench 17 mm
6 Collet
7 Wrench 11 mm
8 Exhaust Hose
9 Muffler
10 Air hose
11 Set Screw
Recommended Accessories
13 Coupling with min ID 5.5 mm/ 7/32"
14 1/2" -Service Unit ( Capacity 5-8
Micron). with wet air include
Lubricator
without oil with oil
300 330
0.70 0.81
21.0 20.5
0,60 0,59 m
23.5 23.1
0,67 0,66 m
14000 17000 rpm
81 dB(A)
< 2.5 m/s
0.88 kg
3/4/4
8 mm/5/16"
up to 1/4"
Suitable Tools:
General:If possible always mount shank in
collet until it bottoms out.
Watt
15 Disc Pd holders up to 3" dia.
16 Burs, specialty abrasives,
N m
materials conditioning products
cfm
17 Mounted points, Attention: always
3
/min
observe mounting instructions.
cfm
Additional Abrasives and Tools
3
/min
can be found in the the SUHNER catalogs
Air supply requirements:
The DIN ISO quality specifications require, that
air is free of solid particles larger than 5
micron, remaining water content to be max. 6
3
g/m (pressure dew point +3 degree C) and
air may contain 5 mg/m
please observe the following:
• Operating with dirty and unlubricated air
2
reduces tool life substantially.
Before installing extension hoses, blow them
clean and minimize , if at all necessary
coupling and keep them clean.
• Rust will occur,if air supply is not lubricated
and wet. A few drops of air tool oil from time to
time will prevent rust and stops bearings from
seizing.
• Conserve:
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions:
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
protect mounted points from knocks and
grease.
• Secure work, use clamps or a vise to hold
work.
• The grinder operator shall wear safety
goggles or face shield at all times when the
grinder is in operation.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear protection
(plugs and/or ear mufflers).
GB
3
of oil. Therefore