Getting Started; Choosing A Location; Installation - Clarity POWER 420 Guide De L'utilisateur

CHOOSING A LOCATION

1. This phone requires a modular phone
jack (RJ11C) and a standard 120V
AC wall outlet.
2. Plug the AC Adapter directly
into outlet.
3. Do not plug other appliances into the
same outlet or have outlet controlled
by a wall switch.
4. Choose a location that is out of the
way of normal activities.
CAUTION: USE ONLY WITH CLASS 2
POWER SOURCE 9V DC, 400mA.
Always connect the AC Adapter to the phone
before you connect it to the AC power.
When you finish, disconnect the AC power
before you disconnect it from the phone.

INSTALLATION

Connecting Your Telephone
Carefully remove your cordless telephone
from it's box. If there is any visible damage,
do not attempt to operate this equipment.
Return it to the place of purchase.
Check to be sure that you have all items that
come with your telephone. You should have
a HANDSET, BASE UNIT, AC ADAPTER, TELE-
PHONE LINE CORD, BELT CLIP AND OWNERS
MANUAL. A BATTERY is also included and is
located in the battery compartment.
8

Getting Started

Diagram A: Table/Desktop Installation
If at any time you have questions about
your telephone please contact our Customer
Service Department at: 1-800-552-3368 or
423-622-7793.
Table/Desktop Installation
1. Plug one end of the supplied modular
2. Plug the modular telephone line cord's
3. Insert the supplied AC Adapter's plug
4. Plug the adapter into a standard
5. Lift the base's antenna to a vertical
USE ONLY WITH CLASS TWO
POWER SOURCE
PULSE/TONE BOOST
ON/OFF
telephone line cord into the jack marked
TEL located on the back of the telephone
base as shown in Diagram A.
other end into a modular phone jack.
into the jack marked 9V DC 400mA
located on the back of the telephone
base.
120V AC power (electrical) outlet.
position.
9VDC TEL
500mA