Bimar VPN40 Notice D'instructions page 20

6. Attach the rear grid (7) to the crankcase and check that the handle (22) is on
the upper part, positioning it so that the pins fit into the corresponding holes,
and lock it with the ring nut.
7. Place the fan (5) on the motor shaft (8) and secure with the ring nut provided
screwing it counter-clockwise so as to tighten it.
8. Couple the front grid (2) to the rear grid (7), lock them in place with a plastic
ring and then secure everything with the special screw/nut (13), (the screw
should be on the lower part). Thereafter, check that the protective grids are
firmly secured to the motor.
9. Insert the steam pipe (14) into the hole in the front grid as far as it will go, if
not previously secured to the seat (9) on the main body. Thereafter, check
that the pipe is firmly secured.
The appliance comes with the following parts:
Water tank (17): remove it from the body, turn the tank upside down and
-
unscrew the cap turning anticlockwise; add demineralised water (without
limescale), and free of additives (essences, detergents, or similar), do not fill
above the max level (about 2L), then close the cap clockwise carefully. Place
the tank on the body in its place: check that it is properly inserted. When the
water is finished, no steam will come out and the "
lights up and you will hear a "beep". Press the spray button to turn off the
light and the acoustic signal.
Wheels, see above.
-
The fan functions are operated from the control panel keypad and with the
remote control pointed at the front (max distance of about 4m) in the direction
of the control panel. First you must insert the batteries (open the rear battery
compartment lid and insert two "AAA" batteries checking the correct polarity,
replace lid), not included in the package.
Stand/by-ON "
-
by
Running the fan: the three speeds are selected by pressing "
-
symbol corresponding to the selected speed lights up: (L = min; M = med; H =
max).
Modes: the three modes are selected by pressing "
-
work both at a constant speed "
": to operate the fan or deactivate it by putting it on stand-
" as well as at two different speeds that
20/60
" water end indicator
the fan can
":
": the