Winding The Bobbin Thread - JUKI DLN-6390 Manuel D'utilisation

Pitch U-Gear marking
2.1 mm (12-stitch/inch)
2.3 mm (11-stitch/inch)
2.5 mm (10-stitch/inch)
2.8 mm (9-stitch/inch)
3.2 mm (8-stitch/inch)
3.6 mm (7-stitch/inch)
4.2 mm (6-stitch/inch)
＊ For the respective gears, one setscrew (Part No. : SM6050802TP) is necessary respectively.

5. Winding the bobbin thread

Perform threading the bobbin winder as shown in the fi gure.
1) Adjust screw 1 so that the winding amount of bobbin should be 80%.
(The percentage is regarded as 100% when the thread is wound up to the outer diameter of bobbin.)
2) When there is uneven winding of the bobbin, loosen screw 2 and move 3 in the direction of the arrow mark to adjust
so that there is no uneven winding.
When uneven winding of bobbin is especially excessive, the bobbin with thread protruded from the
outer diameter is set to the sewing machine and unexpected sewing trouble may be caused.
JUKI Part No.
33 40068710
36 40068709
37 40068712
39 40068706
41 40068707
44 40068708
47 40068711
1
– 24 –
L-Gear marking JUKI Part No.
47 40068711
44 40068708
43 40068713
41 40068707
39 40068706
36 40068709
33 40068710
80 %
Remarks
Optional
Accessories
Optional
Replace the standard U-Gear
with the standard L-Gear.
Standard
Accessories
Optional
Protrusion of thread
3
2