Working With The Operating Menu - Sennheiser ew 300 g2 Notice D'emploi

Working with the operating menu

By way of example of the "Tune" menu, this section describes how to use the
operating menu.
After switching the unit on, the standard display is shown on the display
panel.
EM 300 G2
Transmitters
Getting into the operating menu
Press the
menu. The last menu selected flashes on the display. With the receiver,
the current setting is additionally displayed.
Selecting a menu
Press the
Press the
With the transmitters, the current setting that can be adjusted flashes on
the display. With the receiver, the name of the menu and the current
setting are displayed.
Adjusting a setting
Press the
By briefly pressing the / buttons, the display jumps either forwards or
backwards to the next setting. In the "Channel", "Tune" and "Name"
menu, the / buttons feature a "fast search" function. If you hold down
a button, the display cycles continuously. The "fast search" function
allows you to get fast and easily to your desired setting. With the
transmitters, the new setting flashes on the display until it is stored.
Storing a setting
Press the
indicating that the setting has been stored. The display then returns to
the top menu level.
With most menus, new settings become effective immediately without
having to be stored. An exception are the "BANK", "CHAN", "TUNE" and
"RESET" menus of the transmitters and the "Reset" menu of the receiver.
With these menus, new settings only become effective after they have
been stored and "Stored" had appeared on the display.
SET button to get from the standard display into the operating
/ buttons to select a menu.
SET button to get into the setting mode of the selected menu.
/ buttons to adjust the setting.
SET button to store the setting. "Stored" appears on the display,
21