Sennheiser ew 300 g2 Notice D'emploi page 58

Connecting the amplifier/mixing console
The EM 300 G2's audio outputs are available as an XLR-3M socket
¼" (6.3 mm) jack socket
units (e.g. amplifier, mixing console). The adjusted audio output level is
common for both sockets.
Connect the amplifier/mixing console to the XLR-3M socket
¼" (6.3 mm) jack socket
For detailed information on balanced and unbalanced connection, please
refer to the section "onnector assignment" on page 41.
Via the operating menu, adapt the level of the audio output (AF OUT) to
the input of the amplifier or mixing console (see "Adjusting the audio
output level (EM 300 G2 only)" on page 31).
Service interface
The service interface is only required for servicing purposes.
19" rack adapter and antenna mount
For mounting one or two receivers into a 19" rack, you require the GA 2 rack
adapter (available as an accessory). The GA 2 rack adapter consists of:
2 rack mount "ears"
1 connecting bar
1 connecting plate
2 covering plugs for antenna holes
12 recessed head screws M 3x6
2 recessed head screws M 6x10
When mounting only one receiver into a rack, you can use the AM 2 antenna
mount (available as an accessory) to mount the transmitter's antenna
connection to the front of the GA 2 rack adapter. The AM 2 antenna mount
consists of:
2 BNC extension cables (screw-in BNC socket
2 plains washers
2 nuts
, allowing you to simultaneously connect two
.
to BNC connector
and a
or the
)
13