Indications And Displays On The Transmitters - Sennheiser ew 300 g2 Notice D'emploi

10
Diversity display
The EM 300 G2 receiver operates on the true diversity principle (see
"Diversity reception" on page 39).
The diversity display indicates whether diversity section I (i.e. antenna 1)
or diversity section II (i.e. antenna 2) is active.
Button backlighting
In standby operation, the ON
switched on, the SET button
backlit in green.

Indications and displays on the transmitters

Operation and battery status indication
The red LED (LOW BAT/ON) provides information on the current operating
state of the transmitter:
Red LED lit up: The transmitter is switched on and the capacity of the
batteries/accupack BA 2015 is sufficient.
Red LED flashing: The batteries are/the accupack BA 2015 is going flat
(LOW BAT)!
In addition, the 4-step battery status display
information on the remaining battery/accupack BA 2015 capacity.
3 segments:
2 segments:
1 segment:
Battery icon flashing:
"MUTE" display
The "MUTE" display appears on the display panel when the transmitter is
muted (see "Muting the transmitters" on page 19).
Modulation display
The level display for audio signal "AF" shows the modulation of the
transmitter. When the transmitter's audio input level is excessively high, the
level display for audio signal "AF" shows full deflection.
button is backlit in red. When the receiver is
and the / button
on the display panel provides
capacity approx. 100 %
capacity approx. 70 %
capacity approx. 30 %
LOW BAT
are additionally