Troubleshooting - Tribest SB-130 Mode D'emploi

TROuBLesHOOTIng

Problem
Screen slips
off head unit
Ingredients not
fully ground
Overflow
Alarm doesn't
sound
Milk scorches
Milk too thin
Heating,
but motor not
operating
Doesn't
activate when
buttons are
pushed
16
Probable Cause
Improperly fitted over
threads
Too much or too little in
screen
Not enough water in the
chamber
Screen is clogged
Too much water in the tank
Screen is clogged
Water level too low
Water temperature too cold
Motor or shaft clogged
Not enough ingredients in
screen
Too much ingredients, too
little water
Screen is clogged
Not enough ingredients in
screen
Ingredients not soaked
long enough
Check for clogs and
operating errors
Water entered inside of
head unit
Solution
Re-secure screen by twisting counter-
clockwise
Refill screen to recommended amount
Fill chamber to a level between the two
inscribed marks
Clean with the cleaning brush
Adjust water level to within the inscribed
marks
Clean with the cleaning brush and hot,
soapy water
Fill chamber to a level within the inscribed
marks
Warm water to 10°C-40°C( 50°F-104°F)
Clean
Try again – use the measuring cup when
filling the screen
Try again – fill water in between recom-
mended fill lines. Use the measuring cup
when filling the screen
Clean with the cleaning brush and hot,
soapy water
Try again – use the measuring cup when
filling the screen
Refer to suggestions in operating instructions
Power off and restart. Refer to manual for
operating instructions
Wait 4-5 days for head unit to dry. Try
again