Pattfield Ergo Tools PE-ARM 3440 Li Traduction De La Notice Originale page 68

i) Stop the blade(s) if the machine has
to be tilted for transportation when
crossing surfaces other than grass,
and when transporting the machine
to and from the area to be used.
j) Never operate the machine with de-
fective guards or shields, or without
safety devices, for example deflec-
tors and/or grass collector, in place.
k) Switch on the motor carefully ac-
cording to instructions and with feet
well away from the blade(s).
l) Do not tilt the machine when switch-
ing on the motor, except if the ma-
chine has to be tilted for starting. In
this case, do not tilt it more than ab-
solutely necessary and lift only the
part, which is away from the opera-
tor.
m)Do not start the machine when
standing in front of the discharge
opening.
n) Do not put hands or feet near or un-
der rotating parts. Keep clear of the
discharge opening at all times.
o) Do not transport the machine while
the motor is running.
p) Stop the machine, and remove bat-
tery packs. Make sure that all mov-
ing parts have come to a complete
stop.
- whenever you leave the machine,
- before clearing blockages or un-
clogging chute,
- before checking, cleaning or work-
ing on the machine,
- after striking a foreign object. In-
spect the machine for damage and
make repairs before restarting and
operating the machine.
If the machine starts to vibrate ab-
normally (check immediately):
- inspect for damage,
- replace or repair any damaged
parts,
134 EN
- check for and tighten any loose
parts.
q) Avoid using the machine in bad
weather conditions especially when
there is a risk of lightning.
r) Disconnect the unit from the power
supply (i.e. remove the plug from the
mains, remove the disabling device
or removable battery)
- whenever the unit is left unat-
tended;
- before clearing a blockage;
- before checking, cleaning or work-
ing on the unit;
- after striking a foreign object;
- whenever the unit starts vibrating
abnormally.
MAINTENANCE AND STORAGE
a) Keep all nuts, bolts and screws tight
to be sure the machine is in safe
working condition.
b) Check the grass collector frequently
for wear or deterioration.
c) On machines with multi blade, take
care as rotating one blade can cause
other blades to rotate
d) Be careful during adjustment of the
machine to prevent entrapment of
the fingers between moving blades
and fixed parts of the machine.
e) Always allow the machine to cool
down before storing.
f) When servicing the blades be aware
that, even though the power source
is disconnected, the blades can still
be moved.
g) Replace worn or damaged parts
for safety. Use only genuine re-
placement parts and accessories.
ADDITIONAL SAFETY INSTRUC-
TIONS ON RISKS DUE TO VIBRATION
a) The declared vibration data repre-
sents the main applications of the
appliance, but different uses of the
appliance or poor maintenance can
result in different vibration data. This
may significantly increase the vibra-
tion level over the total working pe-
riod.
b) Additional safety measure shall be
taken to protect the user from ef-
fects of vibration. Maintain the ap-
pliance and its accessories, keep
hands warm and organize work pat-
terns and periods.
FOR USE OF BATTERIES
a) Do not open, dismantle, shred or
short-circuit batteries. Danger of ex-
plosion.
b) Batteries (battery pack or batteries
installed) shall not be exposed to ex-
cessive heat such as sunshine, fire
or the like. Protect from mechanical
shock. Keep dry and clean. Keep
away from children.
c) Dispose of properly. Pay attention
to environmental aspects of battery
disposal. Do not dispose of in house-
hold waste.
d) Remove batteries when not using
the tool for a longer period of time.
e) In case of battery leakage, remove
the batteries and clean the battery
compartment thoroughly. Avoid con-
tact with skin and eyes.
f) In case of damage and improper use
of the battery, Vapours may be emit-
ted. Provide for fresh air and seek
medical help in case of complaints.
The vapours can irritate the respira-
tory system.
For safety instructions for the bat-
tery charger please refer to the
manual of the charger.
For safety instructions for Li-ion
batteries please refer to the manual
of the batteries.
EN 135