Hoshizaki KMD-201AA Notice D'utilisation page 5

ENGLISH
5) Rinse thoroughly with fresh water and a clean cloth to wipe off the
solution. Close the Bin Door.
Note: Some solutions may cause damage to the Bin liner surfaces
or corrosion on the metal parts. Always rinse the sanitiser
unless directed otherwise by Hoshizaki guidelines.
[4] Air Filter
A plastic mesh Air Filter removes dirt or dust from the air, and keeps
the Condenser from getting clogged. As the Filter gets clogged, the
icemaker's performance will be reduced.
) Remove the Air Filter.
Note: Do not put your hand inside the machine compartment.
2) Clean the Air Filter by using a vacuum cleaner. When severely
clogged, use warm water and a neutral cleaner to wash the Air
Filter.
3) Rinse and dry the Air Filter thoroughly, and place it in position.
[5] Icemaking Water System
To keep the icemaker hygienic, periodic cleaning of the icemaking
water system is recommended. Always ask a trained service person
to clean the water system.
Note: . The Washing Switch on the Control Box is intended for use
by service personnel only.
2. During normal icemaking operation, keep the Washing Switch
in the "ICE" position.
2. BEFORE CALLING A SERVICE AGENT
If the icemaker does not work properly or does not work at all, before
calling for service, check that:
* The power is supplied to the unit.
* The Control Switch is in the "ICE" position.
* The water is turned on.
* The Air Filter is clean.
For further assistance or advice, contact your local Hoshizaki service
agent.
3. WARRANTY
Hoshizaki warrants to the original owner/user that all Hoshizaki
branded products shall be free of defects in material and/or
workmanship for the duration of the "warranty period". The warranty
shall be effective for two years from the date of installation. Hoshizaki'
s liability under the terms of the warranty are limited and shall exclude
routine servicing, cleaning, essential maintenance and/or repairs
occasioned by misuse and installations not in accordance with
Hoshizaki guidelines.
Warranty repairs should be completed by an approved Hoshizaki
dealer or service agency using genuine Hoshizaki components.
To obtain full details of your warranty and approved service agency,
please contact your dealer/supplier, or the nearest Hoshizaki Service
office:
Europe
U.K./Ireland - Hoshizaki UK
TEL : +44 (0)845 456 0585
FAX : +44 (0)462 499080
Holland - Hoshizaki Europe
TEL : +3 (0)20 698499
FAX : +3 (0)20 698768
Belgium/Luxemburg - Hoshizaki Belgium
TEL : +32 (0)2 723030
FAX : +32 (0)2 72303
Germany/Switzerland/Austria - Hoshizaki Deutschland
TEL : +49 (0)254 9280
FAX : +49 (0)254 92828
France - Hoshizaki France
TEL : +33 (0) 48639380
FAX : +33 (0) 48639388
Spain/Portugal - Hoshizaki Iberia
TEL: +34 (0)93 4780952
FAX: +34 (0)93 4780900
Other countries - Hoshizaki Europe
TEL : +3 (0)20 698499 or +44 (0)845 456 0585
FAX : +3 (0)20 698768 or +44 (0)462 499080
Other than Europe
Hoshizaki Singapore
TEL : +65 6225 262
FAX : +65 6225 329
Hoshizaki Lancer Pacific
TEL : +6 8 8268 388
FAX : +6 8 8268 978
Hoshizaki Suzhou
TEL : +86 52 62807850
FAX : +86 52 62807860
IV. DISPOSAL
Comply with local regulations regarding disposal of the appliance for
its flammable refrigerant and blowing gas.
Correct disposal of this product:
This marking indicates that this product should not
be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, use
the return and collection systems or contact the retailer
where the product was purchased. They can take this
product for environmental safe recycling.
This product includes a hermetically sealed refrigeration system
that contains fluorinated greenhouse gases covered by the
Kyoto Protocol:
KMD-201AA
KMD-201AWA
4
R404A / GWP 3260 / 0.52kg
R404A / GWP 3260 / 0.40kg