Parallel Connection - ABB Busch-Wächter GJ B000 6132 A0137 Mode D'emploi

Parallel Connection

GB
• After completion of the testing phase, set the "Lux 1" potentiometer to a
5
different setting than "Test": e.g., to 300 Lux (as shown).
500 100
The setting of all three potentiometers are then active again.
7. Special Features i. t. c. of "Parallel Connection" (transmission of cyclic ON telegrams)
a. In the case of Test Mode
If several Presence Detectors are connected in parallel, the "cycle time" must be less than
10 seconds. The stairway lighting function in the actuator must also be set to less than 10
seconds.
b. In the case of Normal Mode
In order to prevent the bus being overloaded when several Presence Detectors are
connected in parallel, increase the "cycle time" in the sensor and the setting of the stairway
68
lighting function in the actuator to at least 3 minutes via the ETS.