Switch-Off Delay "Lighting - ABB Busch-Wächter GJ B000 6132 A0137 Mode D'emploi

Mode of Operation GB
- If the value measured is higher than the set limit value, the lighting remains switched off.
- If the value measured is lower than the set limit value, the lighting is switched on
when a movement is detected.
NOTE
A brief increase in the brightness of the light outdoors does not immediately lead to the
lighting being switched off. If the subjective impression is that the lighting is automati-
cally switched off too soon/too late, a higher/lower Lux value should be set.
Ensure that undesired switching off is not caused by selection of a too short switch-off
delay on the "Light" potentiometer.
10

5.4 Switch-off Delay "Lighting"

30
sec
20
The function "switch-off delay" is defined by the lens system (detection) and the
1
15
"Light" potentiometer. min
10
5
63
Via the lens system, the Presence Detector determines whether there is movement in the
room. The setting on the "Light" potentiometer defines how long the lighting remains
switched on after the last movement has been detected.
The switch-off delay is reset to the selected time value (e.g., 20 min.) after each new