Pentair OPTIFLO Manuel D'instructions page 6

2
13. It is essential that the suction line be free of air leaks and air traps.
Blockage of suction fittings can cause severe or fatal injury due to drowning. Do not permit children to use
pool/spa equipment.
14. Suction fittings must conform to ASME/ANSI A 112.19.8 M Standards. Use double suction fittings.
15. The maximum operating pressure of this unit is 25 psi (1.7 bar). Never operate this pump above this pressure.
This pump is not intended to be operated in series with other pumps.
To reduce the risk of injury, do not permit children to use this product.
16. Wiring of this pump should be performed by a licensed electrician in accordance with the National Electrical
Code or your local electrical code.
Never work on pump while it is running or power is still connected; hazardous voltage can cause severe or fatal
injury. A suitable ground fault interrupter should always be installed at the power supply source of this unit.
17. The pump motor must be wired for the proper voltage in accordance with the wiring diagram supplied with the
motor. Wiring the motor with the incorrect supply voltage will cause damage to the motor and void the warranty.
18. The wiring to the motor should be kept as short as possible and large enough NOT to cause an excessive voltage
drop. Use the wire size table as a guide in selecting minimum conductor size.
19. Install, ground and bond wire according to local or National Electrical Code requirements.
OPTIFLO Aboveground Pool Pump Installation and User' s Guide
WARNING
WARNING
WARNING