L2 Features > Fdb > Static Fdb > Multicast Static Fdb; L2 Features > Fdb > Mac Address Table Settings - D-Link EasySmart DGS-1100 Série Manuel D'utilisation

Masquer les pouces Voir aussi pour EasySmart DGS-1100 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4 Configuration
The fields that can be configured for Unicast Static FDB are described below:
Item
Port
VID
MAC Address
Click Apply to make the configurations take effect.
Click Delete All to delete all the entries found in the display table.
L2 Features > FDB > Static FDB > Multicast Static FDB
The Multicast Static FDB page allows user to view and configure the static multicast forwarding settings on
the Switch.
The fields that can be configured for Multicast Static FDB are described below:
Item
From Port / To Port
VID
MAC Address
Click Apply to make the configurations take effect.
Click Delete All to delete all the entries found in the display table.
Click Delete to remove a specific entry.
L2 Features > FDB > MAC Address Table Settings
The MAC Address Table Settings page allows user to view and configure the MAC address table's global
settings.
Figure 4.24 – L2 Features > FDB > Static FDB > Unicast Static FDB
Description
Allows the selection of the port number on which the MAC address
entered resides.
Enter the VLAN ID of the VLAN which the corresponding MAC
address belongs to.
Enter the MAC address to which packets will be statically forwarded
or dropped. This must be a unicast MAC address.
Figure 4.25 – L2 Features > FDB > Static FDB > Multicast Static FDB
Description
Enter the appropriate port range used for the configuration.
Enter the VLAN ID of the VLAN the corresponding MAC address
belongs to.
Enter the static destination MAC address of the multicast packets.
This must be a multicast MAC address. The format of the
destination MAC address is 01-XX-XX-XX-XX-XX.
D-Link Smart Managed Switch User Manual
Table 4.11
Table 4.12
2
2
3
3

Publicité

Chapitres

Table des Matières
loading

Table des Matières