D-Link EasySmart DGS-1100 Série Manuel D'utilisation page 22

4 Configuration
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. You can select From Port / To Port to control the PoE functions of
a port. The DGS-1100-05PD/08P will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
The fields that can be configured for PoE Configuration are described below:
Item
From Port / To Port
State
Priority
Legacy Support
Power Limit
Max. Wattage
Click Apply to make the configurations take effect.
0 Default
1 Optional
2 Optional
3 Optional
4 Optional
Note: The PoE Status information of Power
current, Power Voltage, and Current is the power
usage information of the connected PD; please
"Refresh" to renew the information.
Figure 4.18 – System > PoE > PoE Configuration
Description
Specifies the PoE function of a port or ports.
Select enable or disable to configure PoE function for
designated port(s). Default is Enabled.
Configure the power supply priority as "Low", "Normal", or
"High" on designated port(s). Default is Normal.
Specify to enable or disable detecting legacy PDs signal
This function allows you to manually set the port power current
limitation to be given to the PD. To protect the DGS-1100-
05PD/08P and connected devices, the power limit function will
disable the PoE function of the port when the power is
overloaded. Select from "Class 1", "Class 2", "Class 3",
"Class 4" and "Auto" for the power limit. "Auto" will negotiate
and follow the classification from the PD power current based
on the 802.3at standard.
Check the box and input the power budget (from 1000 to 8000
milliwatts for DGS-1100-05PD and 1000 to 30000 milliwatts for
DGS-1100-08P) to manually assign an upper limit of port
power budget on designated port(s).
Table 4.5
1 1
D-Link Smart Managed Switch User Manual
15.4W
4.0W
7.0W
15.4W
30W
9 9