System > Port Configuration > Jumbo Frame; System > Poe > Poe System (Dgs-1100-05Pd/08P Only) - D-Link EasySmart DGS-1100 Série Manuel D'utilisation

4 Configuration
The fields that can be configured for Port Settings are described below:
Item
From Port / To Port
State
Speed
Flow control
Description
Capability Advertised
Click Apply to make the configurations take effect.
Click Refresh button to update the port status information.
System > Port Configuration > Jumbo Frame
D-Link Smart Managed Switches support jumbo frames (frames larger than the Ethernet frame size of 1536
bytes) of up to 9216 bytes (tagged). This function is disabled by default. Select Enabled then click Apply to
turn on the jumbo frame support.
System > PoE > PoE System (DGS-1100-05PD/08P only)
The PoE System page will display the PoE status including System Budget Power, Support Total Power,
Remainder Power, and the ratio of system power supply.
Figure 4.15 – System > Port Configuration > Port Settings
Description
Select a range of ports to be configured.
Enable or disable the specified ports.
Copper connections can operate in Forced Mode settings 1000
Mbps (full-duplex), 100 Mbps (full/half-duplex), 10 Mbps
(full/half-duplex), Auto, or Disabled. The default setting for all
ports is Auto.
You can enable this function to mitigate traffic congestion.
Ports configured for full-duplex use 802.3x flow control, half-
duplex ports use backpressure flow control. The default setting
is Disabled.
Specify a description for the chosen ports
When the Speed is set to Auto, these capabilities are
advertised during auto-negotiation.
Table 4.3
NOTE: Be sure to adjust port speed settings
appropriately after changing the connected cable
media types.
Figure 4.16 – System > Port Configuration > Jumbo Frame
1 1
D-Link Smart Managed Switch User Manual
7 7