Table des Matières
Publicité
Communication Fieldbus / appareil de mesure
Paramètres du bus Standard Transducer Block (TB)
Parameter
Mettler-Specific Parameters – Temperature
17 SECONDARY_VALUE_2
18 SECONDARY_VALUE_UNIT_2
19 TEMP_SENSOR_TYPE
20 TEMP_COMPENSATION
21 TEMP_COEFFICIENT
22 TEMP_WIRE_IMPEDANCE
23 TEMP_SENSOR_CAL
Mettler-Specific Parameters – Calibration
24 CELL_CONSTANT
25 CAL_SAMPLE_PRD
26 CAL_SAMPLE_PRD_STORED_VAL Shows the stored value of the first step of
27 CAL_PRODUCT
86
Description
Process temperature value and status
Value
Status
Degree C or degree F.
Changes the unit of temperature
being displayed and transmitted.
Type of temperature sensor.
The value entered must correspond to the
temp. sensor being used.
Selects the temperature compensation
Sets the temperature coefficient if the
TEMP_COMPENSATION is set to Lin
Sets the wire impedance of the temp.
sensor. Typically 0 unless the wire of the
sensor gets too long
Desired temperature reading, used for
temperature measurement calibration.
Sets the cell constant.
Starts the 1st part of conductivity product
calibration.
conductivity product calibration
Sets the value for the 2nd part of
conductivity product calibration.
Transmetteur Cond 7100e FF
Publicité
Table des Matières
