Special Information; Eu Declaration Of Conformity - Beta 3027/10 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

INSTRUCTIONS FOR USE

WARNING

NEVER OPERATE THE WINCH WITH FINGERS CLOSE TO THE GEAR WHEEL.

IT IS ABSOLUTELY FORBIDDEN TO OPERATE WITH THE BED HANGING BY THE ROPES

OF THE WINCH: ALL WORK OPERATIONS ARE TO BE MADE WITH THE BED RESTING

ON THE PINS AND THE WINCH ENTIRELY FREE.

● Position the prisms (ref. 3, Fig. 3) on the bed (1).

● Insert the lever of the pump (4) into its relative seat (5) on the pump.

● Fig. 5 shows the uses relative to the positions of the two dials on the pump.

● Operate the lever to lower the ram, carry out the work then bring the ram back to rest with the relative dial (Fig. 5).

The pump operating lever is thereby free to be able to be extracted or moved if it gets in the way

of work on the press.

MAINTENANCE

● Oil the moving parts of the press every six months and check operation of the pressure gauge.

● The hydraulic unit (cylinder/pump) is a sealed system that in normal conditions requires only sixmonthly lubrica

tion of the moving parts. In the event of the hydraulic unit leaking oil and being dismantled in order to replace

the seals, it will be necessary to add oil through the filler hole on the pump (ref. 6, Fig. 4) until the pump has

been filled up to the level of the hole itself. This operation has to be done with the ram at rest and therefore

fully retracted. The oil in the hydraulic units should anyhow be replaced every two years independently of the

gene ral conditions of the unit.

Use hydraulic oil with viscosity from 22° to 25°.

Required quantity of oil:

A greater amount of oil could cause trouble

WARNING

NEVER use brake oil.