Special Information; Eu Declaration Of Conformity - Beta 3027 Mode D'emploi

INSTRUCTIONS FOR USE
WARNING
NEVER OPERATE THE WINCH WITH FINGERS CLOSE TO THE GEAR WHEEL.
IT IS ABSOLUTELY FORBIDDEN TO OPERATE WITH THE BED HANGING BY THE ROPES
OF THE WINCH: ALL WORK OPERATIONS ARE TO BE MADE WITH THE BED RESTING
ON THE PINS AND THE WINCH ENTIRELY FREE.
● Position the prisms (ref. 3, Fig. 3) on the bed (1).
● Insert the lever of the pump (4) into its relative seat (5) on the pump.
● Fig. 5 shows the uses relative to the positions of the two dials on the pump.
● Operate the lever to lower the ram, carry out the work then bring the ram back to rest with the relative dial
(Fig. 5).
The pump operating lever is thereby free to be able to be extracted or moved if it gets in the way
of work on the press.
MAINTENANCE
● Oil the moving parts of the press every six months and check operation of the pressure gauge.
● The hydraulic unit (cylinder/pump) is a sealed system that in normal conditions requires only sixmonthly lubrica
tion of the moving parts. In the event of the hydraulic unit leaking oil and being dismantled in order to replace
the seals, it will be necessary to add oil through the filler hole on the pump (ref. 6, Fig. 4) until the pump has
been filled up to the level of the hole itself. This operation has to be done with the ram at rest and therefore
fully retracted. The oil in the hydraulic units should anyhow be replaced every two years independently of the
gene ral conditions of the unit.
Use hydraulic oil with viscosity from 22° to 25°.
Required quantity of oil: 1,2 litre
A greater amount of oil could cause trouble
WARNING
NEVER use brake oil.

SPECIAL INFORMATION

● The waste oil taken from the press has to be disposed of in compliance with the laws in force in
the country where the machine is installed.
● If the press is to be destroyed, all the metal parts can be recycled; the rubber hoses and the press
fluids have to be disposed of in compliance with the laws in force in the country where the machine
is installed.

EU DECLARATION OF CONFORMITY:

BETA UTENSILI S.p.A. hereby declares that hydraulic press 3027 complies with "Machine Directive" 2006/42/EC
MASSIMO CICERI
( Member of the board)
EN
7