Charcoal Filters - FALMEC ARARX36I5SG Livret D'instructions

– and + pushbutton: increase/decrease speed (to start the motor press either
the + or the – pushbutton).
Timer pushbutton: see instructions below.
Instructions for changing the code (only in case of malfunctions caused by
interferences):
Disconnect the hood from the power supply
Remove the cover of the remote control, change the code with the levers.
Connect the hood to the power supply and make sure the lights and the
motors are off.
Press the timer pushbutton for 2 seconds. When the red LED of the control
panel lights up press any of the buttons on the control panel.
Timer and 'filter clogged' alarm pushbutton
• This function allows the automatic turning off of the hood after running for
15 minutes at the speed previously set (the pushbutton shows a flickering
light).
• After about 30 hours of running the pushbutton indicates the need for
washing the metal filters (the pushbutton shows a solid red light). To disable
the alarm press the pushbutton for a few seconds until the red light turns
off. Then turn the hood off and on again to check that the alarm has disap-
peared.
H
FILTERS
1. METAL FILTERS
To remove the metal grease-trapping filter, simply pull the handle A until
releasing it from the front guide; then tilt it slightly downwards, and slide
it out of the rear guide. To reposition the filter, repeat the operation in the
reverse order.

2. CHARCOAL FILTERS

To replace the charcoal filters, proceed as follows: remove the metal filters
as described above. The two filters located at the ends of the motor can now
be easily accessed.
To install the new fi lters see picture.
In case of hood with the motor box the fi lter is located on the botton part of
8
REMOVING AND REPLACING'S INSTRUCTIONS
A