Charcoal Filters - FALMEC Diamante 90 Livret D'instructions

Light pushbutton
• ON: light on (the pushbutton is lit);
• OFF: light off;
Pushbutton -
Press to reduce motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light
and the timer LEDs).
Pushbutton +
Press to increase motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light
and the timer LEDs).
(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set
duration of time. After 15 minutes the motor returns to the third speed).
Mode pushbutton
Function: it turns hood motor on and off.
The function "desired speed" enables to start the motor at the speed that was selected
before the hood was last turned off.
Optional: version with remote control (some versions only).
WARNING:
Install the hood away from sources of electromagnetic waves, as these could affect the
correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance could be less
than 5 metres in case of electromagnetic interference by other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press either the + or
the – pushbutton).
Timer pushbutton: see instructions below.
Timer and 'filter clogged' alarm pushbutton
• This function allows the automatic turning off of the hood after running for 15 minutes
at the speed previously set (the pushbutton shows a flickering light).
• After about 30 hours of running the pushbutton indicates the need for washing the
metal filters (the pushbutton shows a solid red light). To disable the alarm press the
pushbutton for a few seconds until the red light turns off. Then turn the hood off and on
again to check that the alarm has disappeared.
H
FILTERS
1. METAL FILTERS
To reach the metal filters one must remove the three frontal panels (see fig A1 and A2).
To remove the metal filters use the handle.

2. CHARCOAL FILTERS

To replace the charcoal filters, proceed as follows: remove the metal filters as described
14
REMOVING AND REPLACING'S INSTRUCTIONS