Charcoal Filters; Light Bulb - FALMEC PRIMO Livret D'instructions

2. CHARCOAL FILTERS

To replace the charcoal filters, proceed as follows: remove the metal filters
as described above. The two filters located at the ends of the motor can now
be easily accessed.
To install the new fi lters see picture.
To order new filters, use the coupon enclosed with this booklet or provided
by the distributor.
I
LIGHTING

1. LIGHT BULB

To replace the light bulb:
a) Make sure the appliance is disconnected from the mains power supply.
b) Unscrew the support screw A and remove the light cover.
c) Replace the light bulb with the same model as the original (max 25 W, see
the markings near the light).
A
WARNING! Light bulbs with different shapes and power ratings from the
original may seriously damage the light compartment.
2. SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 con-
nection).
d) Close the panel. If the panel does not close correctly repeat the operation
at point b.
A
ASSEMBLY AND REPLACEMENT
9