Programming The "Pumps Controller" Electronic Control Unit - DAB E1GI Instructions Pour L'installation Et La Maintenance

13.
PROGRAMMING THE
The control unit has four standard keys for programming:
Key to confirm the modified value.
Key to choose the number to be modified.
Key to increase the number to be modified or move on to the upper line of parameters.
Key to decrease the number to be modified or move on to the lower line of parameters.
pressed simultaneously (for about 40 sec.) to enable or disable the functions of the
Keys
"Pumps Controller" electronic control unit.
To access programming, proceed as follows
(see table 14 "Display of pages and parameters in the "Pumps Controller" Electronic Control
Unit")
 Disable the "Pumps Controller" control unit, pressing simultaneously (for about 40 sec.) the keys
 The word OFF will appear on the display.
 The main page will appear on the display.
 Press the
appear.
 Press the
key: the 0 farthest to the right will blink.
 Using the key
17), placing the numbers from right to left, moving with the key
 After having inserted the "key", press the
programming list.
 If an incorrect access key has been inserted, the control unit will give the signal:
PASSWORD...
 Repeat the operation described above, inserting the correct key.
 This gives access to the list of parameters.
st
1 parameter to set:
 Press the
key to select the language. 2=ENGLISH
"PUMPS CONTROLLER"
key until the bottom line of all the parameters is shown, the words "insert key" will
insert the DAB STANDARD KEY or the DAB EXTENDED KEY (see tab. 16 and
ENGLISH
ELECTRONIC CONTROL UNIT
key to confirm it and move on to the chosen
40
.
WRONG