Electrical Connection; Lamp Adjustment - Hella 1N3 009 094-011.2 Instructions De Montage

Electrical connection:

Lamp adjustment:

11
Install relay with connection
terminals pointing downwards so
that they are protected against
splashing water.
Install switch in dashboard: Either
switch supplied with set or
special switch for your vehicle.
Have your driving lamps adjusted
at a specialist garage so that
they illuminate the road
effectively without dazzling
oncoming traffic. After adjusting
the lamps tighten the lamp base
on the housing.
One more tip:
•Always keep the cover lenses
clean.Dirt can absorb up to
80% of the light from the
lamps. You drive better when
you can see and be seen well.
Do you have spare bulbs and
fuses in your car?
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according
circuit diagram (page 3).
Special instructions for Germany
only.
The enclosed cap may not be
fitted.
Should you have any queries or
problems about the installation,
please contact the Hella
Customer Service Department
via your local stockist.