Network Configuration; Configuring The Radio Only To Use A Wired Ethernet Connection; Configuring The Radio Only To Use A Wi-Fi Connection - Sangean WFR-20 Mode D'emploi

Network configuration

This menu enables you to configure your radio's network settings,
scan for a connection to an alternative wireless network, or to
manually configure the network parameters. This can be useful if you
take the Internet radio to another location where there is a different
network setup.
It is possible to configure your radio to connect to your network via an
available Ethernet connection (LAN) or via a Wi-Fi router.
Configuring the radio only to use a wired
Ethernet connection
1. From the radio's Network Configuration menu, select 'Wired /
Wireless'. This menu will present you with three options:
'Wireless Only', 'Wired Only'and'Auto'. Selecting 'Wired Only' will
allow cause the radio to restart and then to use only its Ethernet
connection to communicate with the network. The radio will also
disable its wireless network capabilities. This will require your radio
to be physically connected to a wired Ethernet using the LAN
socket on the rear panel.

Configuring the radio only to use a Wi-Fi connection

2. Selecting the 'Wireless Only' option from the 'Wired / Wireless'
menu will allow cause the radio to restart and then only to use only
its Wi-Fi connectiontocommunicatewiththenetwork.
Theradiowillalsodisable its Ethernet connection.
51
54
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:14