Connecting The Radio Using Upnp - Sangean WFR-20 Mode D'emploi

Connecting the radio using UPnP

1. Usethe Select controltoswitchonyourradioandtoaccessthemenus.
If needed, use the Back option. Select the Media Player menu.
Rotate the Select control to highlight 'UPNP Servers'.
2. Press and release the Select control and the radio will scan for all
available UPnP servers. Note, this may take a few seconds for the
radio to complete its scan and before the scan has completed,
the radio will display 'Empty'. The radio will continue to display
'Empty' if no UPnP servers are found.
3. After scanning, select your UPnP server (rotate the Select control
if more than one UpnP server is found), and then press the
Select control. Your radio will normally display 'Access Denied'
at this stage.
4. Your PC may now prompt you that a device has attempted to
connect to your UPnP server. Whether you are prompted or not,
in order to allow the radio to have access to the media files,
you will need to click the 'Library' tab in WMP 11 and select the
'Media Sharing...' item to open the 'Media Sharing' window.
5. From the 'Media Sharing' window, the radio will be listed as an
unknown device. Click on the unknown device shown to select it,
then click the 'Allow' button and then click 'OK'.
Note:
If you are using Microsoft Windows' firewall software, this should be
correctly configured by WMP 11. If you are using third party firewall
software you may need to manually configure it to allow your radio
and WMP 11 to communicate (see 'Troubleshooting').
6. Select the named server again using the Select control. If WMP 11 is
now able to communicate with your radio you will be presented with
some media selection options by the server software.
33
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:13
GB
30