Switching Your Radio On; Volume Control - Sangean WFR-20 Mode D'emploi

Switching your radio on

1. With the radio in Standby mode (displaying the clock), press the
Select control (or the On / Standby button on the remote control).
Rotate the Select control forward and backward to highlight different
elements in the menu.
2. When the first item 'Radio Stations' (or 'Stations') is highlighted,
press the Select control to enter the Radio menu. Alternatively,
you could press the Radio button on the remote control.
3. The Radio menu allows selection of radio station by location and
genre. It also provides access to the radio station presets. When the
radio first connected to the Internet it automatically stored a radio
station in Preset 1. (If you don't like it, you can easily change it
later.) Rotate the Select control so that the station name is
highlighted on the display.
4. Press the Select control once more and the display will show
'Connecting' while it finds the audio stream for the station. After a few
seconds you should hear the radio station, and then the display will
change to show additional information from the broadcast.

Volume control

1. While the radio station is playing with its name on the radio's
display, you can change the volume by rotating the Select control
or by pressing the Volume up and Volume down buttons on the
remote control.
2. If the radio is in its menu-browsing state, you can change the volume
either pressing the Volume up and Volume down buttons on the
remote control, or by waiting for the menu display to time-out
(nominally 15 seconds) and then by rotating the Select control.
15
18
20070929_WFR-20_381R101-A_GB.p65
2007/10/1, ¤U¤È 05:12