Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
1
Pull out the lap counter to the width of the track being used (fig.
Insert the sides of the track into the projections on the inside of the
feet of the lap counter.
Lining up the vehicles
1
2
Line up the vehicles in the direction of driving (fig.
are close to the light barrier (Fig.
) of the lap counter.
2
1
2
The lap counter recognizes a vehicle when it passes through the
).
light barrier. You can either select a race with a specific number of
1
laps (e. g. Formula 1, fig.
hour race, fig.
2
).
einstellen.
3
Settings are made using the two buttons (
tings and the progress of the race are shown on the display (over
1
) so that they
the lanes).
How it works
) or a specific time (e. g. Le Mans 24
1
Settings
C
D
E
and
). These set-
C
E
Switching on
100
100
1
00:44:28
00:41:32
Push the power switch
into the ON position. The display shows
D
the active racing mode (fig.
1
, flashing).
Race modes
100
106
1
00:44:28
00:41:32
100
045
2
00:44:28
00:41:32
Settings for a lap race
Keep one of the buttons (
or
) pressed until the display stops
C
E
blinking (> 2 secs.). The default setting is 100 laps. Press button
again (
or
) for the track you want to make the setting for and
C
E
keep it pressed until the counter begins to automatically count back-
ward.
The units are set first, then the ten and finally the hundreds. The
number of laps ccan be set manually by releasing the button and
then makink shot, intermittent presses. If you keep the button
pressed for a longer period of time again, the setting process will
begin again with units. Max. number of laps: 999.
Number of laps for second lane
As for the first lane, but using the other button.
9
Publicité
Chapitres
Table des Matières
