Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
100
999
3
00:44:28
00:41:32
045
045
4
00:44:28
00:41:32
100
100
5
00:44:28
00:41:32
6
00:01:00
00:01:00
7
00:70:00
00:70:00
8
60:00:00
60:00:00
10
9
99:59:00
99:59:00
Settings for a time race
When you switch on the lap counter and the display is flashing,
press one of the enter buttons (
or
) briefly until the display
C
E
shows the time race mode (fig.
). Then push one of the buttons
3
(
or
) until the display stops flashing (> 3 secs.).
C
E
Setting the duration of the race for both lanes
Keep one of the buttons (
or
) pressed until the display stops
C
E
blinking (>2sec.).
The defaut setting is 1 second.
Keep one of the buttons (
or
) pressed until the dispay for the
C
E
seconds begins to automatically count forwards. After 1 run through
the display will jump automatically to the minutes. Here, too, you
can release the button and make short, intermittent presses if you
want to set the time manually. If you keep the button pressed for a
longer period of time again, the setting process will begin at the first
position. Max. race length: 99:59:00 minutes.
Start of the race
038
036
1
00:17:55
88:15:62
032
029
2
54:48:27
54:48:27
The start phase of the selected racing mode will begin 10 seconds
after the last press of the enter button. The red LEDs in the set of
starting lights
will light up one after another at intervals of 1.5
A
seconds. At the same time, you can hear an increasingly higher
acoustic signal until all the lights are on.
After two further seconds another long sound can be heard and
all of the lights will go out. The race has been officially started and
you can drive off.
False start: If a vehicle drives off before the race has been officially
started, the lap will not be evaluated for this lane. The count will
begin when the vehicle passes through the light barrier the second
time.
Publicité
Chapitres
Table des Matières
