Setting Mode - AEG GS60AV221 Notice D'utilisation

COMBI DETERGENT TABLETS
These tablets contain detergent, rinse aid
and other added agents. Be sure that
these tablets are applicable to the water
hardness in your area. Refer to the instruc-
tions on the packaging of the products.
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser. The rinse aid
indicator always comes on if the rinse aid
dispenser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the low-
est position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators are off.
• The end indicator flashes.
If the control panel shows other condi-
tions, press and hold the programme but-
ton until the appliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press continuously the programme
button until the indicator of the pro-
gramme you want to set comes on.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button to delay the
start of the programme of 3 hours. The
delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
1. Open the appliance door.
2. Press the delay button, the delay indi-
cator goes off.
3. Close the appliance door. The pro-
gramme starts.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button
until the indicator of the set pro-
gramme goes off and the end indica-
tor flashes.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
ENGLISH
73