Language Selection - Eureka Mythos 220 Manuel D'instructions

EN
Once the password has been entered, it will be requested for access to any programming
function (See SETTING GRINDING TIMES). Once entered, the sequence needs to be
confirmed with the
If the password entered is not correct, the display will read "PSW ERROR" for about 3 sec-
onds before returning to its previous mode.
There is no limit to the error of entering the password.
If the machine should switch off accidentally, the password will remain stored in the memory
only if after the "store" step has been completed during "CONFIRM PSW".
If the user forgets the password, it is possible to access the programming function using the
"RELEASE CODE": press and hold down (for 10 seconds) the
2 seconds, the display will show the message "ENTER PSW", then after 10 seconds, the
message "RELEASE CODE" will appear. At this point, it is possible to enter the following
sequence:
then press the , key to confirm; this will disable the previously set password and make
it possible to access the programming function.
The whole "PASSWORD" function is active for all operating modes; in the "MANUAL" and
"AUTOMATIC" modes it blocks access to all programming. However, in "BARISTA" mode it
is still possible to edit dose times but it is not possible to access counters.
6.4.11

LANGUAGE SELECTION

During programming it is possible to choose the language (Italian, English, French, German,
Spanish) using the flashing key
shown in the centre of the display.
When the key is pressed again, this quits the programming function.
To quit programming at any time without having to view all the steps, press and hold down
the key for 5 seconds.
6.4.12 ADJUSTING LIGHTING DUrING NOrMAL OPErATION
If the keys and
will open the lighting adjustment function for the keys and the display.
mythos
key.
; each time the key is pressed, this selects the mode
CHOOSE LANGUAGE
ITALIAN
NORMAL LIGHT ADJUST
Tm
are held down for 8 seconds from the language select screen, this
>
TM D
keys; after about
19