MSA GALLET F1XF Mode D'emploi page 6

Installation
3.3 Bone Conductive Sensor
The bone conductive sensor could be placed inside the front padding of the headband or inside the
leather pocket hooked to the straps of the suspension system.
3.3.1 Installation in the Front Padding
(1) Open the front padding as shown by
detaching the Velcro fasteners.
(2) Slide the bone conductive sensor inside one
of the two pockets as shown.
3.3.2 Installation in the Suspension System
(1) Install the bone conductive sensor in the
leather pocket.
(2) Turn back the pocket on the straps of the
GB
suspension system and keep the leather
strip open.
(3) Pass the leather pocket strip under the
suspension straps. Close with the Velcro
fastener.
6
(3) Ensure the microphone sensor is positioned
towards the face.
The sensor must touch the forehead
while wearing the helmet.
(4) Place the cable between headband and
headband padding in a way to avoid any
pressure points on the forehead.
(5) Fold back and close the headband by
attaching the Velcro fasteners.
®
GALLET F1XF / Cairns XF1