MSA GALLET F1XF Mode D'emploi page 5

3 Installation
3.1 Flexible Microphone Headset
rear
(1) Insert the hook (A) into its designated slot.
(2) Push the clip (B) into its slot until it clicks.
3.2 Speaker Module (Bone Conductive or Second Speaker)
Check the indication on the back of the module to position it on the proper side of the helmet (L or R).
(1) Insert the hook (A) into its designated slot.
(2) Push the clip (B) into its slot until it clicks.
WARNING!
Ensure that the front retention strap does not obscure field of vision
The headset is installed on the right side of the
front
helmet.
(3) Push the retention clip (3) behind the edge of
the locking clip as shown.
(4) Check the attachment by gently pulling the
module.
(3) For the second speaker (optional), position
the module so that the connecting wire is
located above the suspension straps as
shown.
®
GALLET F1XF / Cairns XF1
Installation
GB
5