Antari Z-1200II Mode D'emploi page 11

After 2,000 hours of operation, we suggest you use distilled water to clean the heater as following steps:
1. Fill proper distilled water into a clean tank and connect the fluid tube of the fog machine to the tank.
2. Run the fog machine in a well ventilated place until the tank is empty.
3. Use a dry cloth to wipe the fog machine.
If the fog machine is not in use, please clean it before storage. Store the fog machine in a dry and cool
place.Run the fog machine at least once a month.
The machine provides a 3 or 5 pin XLR connector for DMX connection.The diagram below indicates pin
assignment information.
Antari Z-1200II, Z-1500II, Z-3000II on-board DMX settings
C hannel A
U
0 - 5 = OFF
6 – 249 = Volume Control ( 5% - 95%)
250 – 255 = Maximum Volume Output (100%)
The Z-1200 II, Z-1500II & Z-3000II Fog Machines have on-board DMX control. These models use 1
channel to control volume output operation. Each channel has a value range of 0 to 255. Timer functions
such as duration and interval can be programmed using the DMX controller or the DMX control software
being used by the lighting and effects operator.
Please read and save these instructions.
DMX Connector Pin Assignment
Pin
1
2
3
4
5
Function
Ground
Data-
Data+
N/A
N/A
11