Fitting And Adjusting The Longitudinal Stop; Working Instructions - ATIKA T 250 ECO Notice Originale

Fitting and adjusting the longitudinal
stop
Fit the longitudinal stop to the saw table plate.
The longitudinal stop (13) can be installed on the left or right of
the saw blade. To attach the fence (7A) on the other side of the
stop,
loosen the both knurled nuts (C),
remove the fence (13A),
unscrew the two knurled nuts,
attach the guide plate (13B) on the other side of the stop,
reinstall the fence.
Make sure that the fences are correctly adjusted. (See

"Working instructions").

Setting the longitudinal stop
1. Place the longitudinal stop (13) in the guide profile on the
bench.
2. Set the desired dimension and turn the lever (25) down.
3. To obtain a precise cut, first make a test cut and then
readjust the stop as needed.
Working instructions
Before starting to work consider the following safety
advices to keep the risk of injuries as small as possible.
Protective guard, splitting wedge and saw blade ok?
Place your hands flat on the workpiece with fingers closed.
Stoppers (fences) ready for use and pushstick to hand?
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Before making adjustments to the saw settings (e.g.
replacing the saw blade etc.)
− switch off device
− Wait for standstill of the saw blade
− pull out main plug
Also, note the following important points:
Place yourself outside of the area of danger.
Place your hands flat on the workpiece with fingers closed.
With it, lead the work piece with the hand only up to the
leading edge of the saw blade protection.
Never remove loose splinters, chips, or similar by hand.
Ensure that you always comply with the safety instructions
given on p. 18.
23