Commissioning; Adjusting The Saw - ATIKA KGSZ 210 Instructions D'utilisation

Commissioning

Mains connection
Compare the voltage listed on the device type plate, e.g. 230 V,
with the mains voltage and connect the device to the corre-
sponding and proper socket.
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with residual cur-
rent circuit breaker (FI switch 30 mA).
Main fuse: 10 A inert
Use the connection or extension cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
1.5 mm for cable lengths up to 25 m
2
2.5 mm for cable lengths over 25 m
2
On / Off Switch
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switch on
Activate the On/Off switch (2).
Switching off
Release the On/Off switch again.
Dust/chip exhaustion
The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
Unless the machine is used outdoors, the dust bag (18) or a
chip exhaust system (e.g. portable dust remover) must be con-
nected.
Dust bag
When using the dust bag:
push the dust bag (18) onto the exhaust neck (19).
regularly empty the dust bag
Chip exhaustion
Connect a chip exhaust system or small vacuum cleaner
with suitable adapter to the chip exhaust neck (19) (dia. 37 mm).
Air velocity at the exhaust neck of the saw ≥ 20 m/sec
Use a special exhaust device when exhausting dusts that are
especially harmful to health, carcinogen or dry.
Attaching table extensions
Handling long work pieces with the help of the supplied
support arms.
The support arms can be mounted to the left and right of the
machine.
- Insert the support arms (12) into the respective holes
on the sides.
- Secure the support arms with the wing screws (31).
Safely support long work pieces with suitable means. For exam-
ple, use saw horses or similar devices to support overhanging
work pieces.
Vise assembly
Always secure work pieces to be handled. Do not cut
work pieces that cannot be secured with the vise assembly.
The vise assembly can be positioned to the left or right of
the saw head.
- Insert the vise assembly (10) at the right or left into the
hole provided.
- Secure it with the wing screws (13).
- Press the work piece firmly against the work piece stop
(29).
- Turn the machine knob of the vise assembly clockwise.

Adjusting the saw

Pull the mains plug before performing
settings.
Setting the work piece stop
To adjust a work piece stop that has shifted during trans-
port, proceed as follows:
1. Set the rotary table (32) to the 0° position and tighten the
fastening bolts for the rotary table (7). (see "Straight cuts").
2. Position the saw head in transport position (see "Transport")
3. Check the angle between saw blade and work piece stop
using a square (A, not supplied).
4. Loosen the set screws (2 on each side) for the work piece
stop (30) if the work piece stop needs to be adjusted
5. Align the work piece stop along the square and tighten the
locking screw again.
Adjusting the incline of the saw head
Also check the angle of the saw head to the rotary table.
1.
Set the saw head to the transport position and the rotary
table to 0°. Verify the angle with a square (A, not supplied)
or protractor.
Proceed as follows if the angle is not exactly 90°:
23
C
D
E
F