Maintenance And Care - ATIKA T 250 ECO Notice Originale

Cutting narrow workpieces
(Width less than 120 mm)
Push the workpiece forward with both hands, in the area
of the saw blade, use the pushstick (19).
When working on very flat and narrow workpieces (Width
30 mm and less) use the lower guide are of the fence
(13A).
Cutting wide workpieces
With the flat of the
hand and the
fingers closed,
push the work
piece to be cut
along the stop.
Cross cuts / mitre cuts
Push the trans-
verse stop (11) into
one of the guide
grooves on the
table and set the
transverse stop to
the required angle.
Push the longitudi-
nal stop (13) into
the required posi-
tion, so that the
work piece can be
securely held in
place.
Place the work-
piece to be cut
against the stop
rails.
Hold the workpiece firmly in place and push it past the saw
blade using the transverse stop. Use the pushing bar if
necessary.
24

Maintenance and Care

Before each maintenance and cleaning
work
− switch off device
− wait for stop of chain saw
− pull out main plug
Further maintenance and cleaning works than described in this
chapter shall only be carried out by the manufacturer or
companies named by the manufacturer.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Cleaning
Observe the following to maintain the functionality of the
saw.
Do not wash down device with water.
Remove splints and sawdust only with a brush or vacuum
cleaner.
Clean and oil all moving parts regularly.
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
Take care that the saw blade remains free of rust and resin.
Remove all resin residues from the saw bench top
Resin residues can be removed with a commercial
maintenance and care spray.
The saw blade is a wearing part and will become dull after
prolonged or frequent use.
renew the saw blade or have it sharpened
Maintenance
Changing the saw blade
Before replacing the saw blade remove the
plug from the mains.
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have
changed their shape.
Only use well-sharpened saw blades
Replacing the table insert
Immediately replace a worn or damaged table insert.
(p. 84 - p. 88)