Adjust Saw Blade Pitch; Fitting And Adjusting The Transverse Stop; Fitting And Adjusting The Longitudinal Stop; Working With The Saw - ATIKA PTK 250 S Notice Originale

Adjust saw blade pitch

The saw blade must not be set to the inclined position
when the blade is turning. The motor must be switched
off first.
Adjusting between 0° - 45°
, Loosen the clamping screw (20).
Press in the handwheel (19) and rotate it until the desired
angle (0° - 45°) is indicated.
Retighten the set screw.
Adjusting the angle indicator:
Turn the machine off and unplug the power cord.
Use an angle stop to align the saw blade vertically.
Loosen the screw (A) and slide the angle indicator to
the 0° mark.

Fitting and adjusting the longitudinal stop

Fit the longitudinal stop to the saw table plate.
Mount the stop bar (5) using the 2 supplied star gips,
hexagon screws and washers on the stop support.
Make sure that the stop is correctly adjusted (see

"Working with the saw").

Setting the longitudinal stop
Place the longitudinal stop in the guide profile on the bench.
Set the desired dimension and turn the lever (9) down.
To obtain a precise cut, first make a test cut and then
readjust the stop as needed.

Fitting and adjusting the transverse stop

The transverse stop supplied can be used as a
transverse or mitre stop.
Make sure that the stop is correctly adjusted (see
"Working with the saw").
Use an angle gauge for a correct 90° adjustment.
Fit the transverse stop to the saw table plate
Slide the transverse stop in the groove on the saw
table plate.
Use the sliding carriage for mitre cuts.
Firmly tighten the machine knob (34).
Setting the angle
Loosen the star grip (35) and adjust the mitre guide to
the desired angle.
Retighten the star grip (35).
20
W o r k i n g
W o r k i n
Before starting to work consider the following safety advices to
keep the risk of injuries as small as possible.
Protective guard, riving knife and saw blade ok?
Place your hands flat on the workpiece with fingers closed.
Stoppers (fences) ready for use and pushstick to hand?
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Before making adjustments to the saw settings (e.g. replacing
the saw blade etc.)
− switch off device
− Wait for standstill of the saw blade
− pull out main plug
Also, note the following important points:
Place yourself outside of the area of danger.
Place your hands flat on the workpiece with fingers closed.
With it, lead the work piece with the hand only up to the
leading edge of the saw blade protection.
Never remove loose splinters, chips, or similar by hand.
Observe all safety instructions in any case.

Cutting narrow workpieces

(Width less than 120 mm)
Push the workpiece forward with both hands, in the area
of the saw blade, use the pushstick (26).
When working on very flat and narrow workpieces
(Width 30 mm and less) use the lower guide area of the
fence (5).
w i t h t h e s a w
g w i t h t h e s a w