Reshipping - Glomex DANUBE R8500 Manuel D'installation Et Utilisation

DANUBE R8500
7. The equipment does not find
the satellite (the led on the
control unit flashes
nately red and orange)
8. Disturbed images
9. Confused, incomplete
obstructed images
10. The decoder blocks
11. The equipment operates with
still boat but not with moving
boat
For further information, please address to the
GLOMEX Service Centre (see section "Technical
Support").

11. RESHIPPING

Should you need to return the antenna to
GLOMEX, place it in a box, possibly the original
one, making sure it is well packaged and that the
upper and lower side are well recognizable.
Together with the antenna, please also send the
control unit, so that a verification of the whole sys-
tem is possible.
NOTE: GLOMEX will not be liable for possible
damage occurred during transport due to incorrect
packaging.
- the satellite
obstructed by trees, buildings,
alter- overpasses, mountains
- the equipment software is not
up to date
- wrong SKEW adjustment
- bad weather conditions
- failure of the receiver
and - condensate or rain on the
radome, which can disturb the
signal with still vehicle
- bad weather conditions
- alternating current fluctuations - refer to the user manual of the
- the satellite
obstructed
- failure in the gyroscope sys-
tem
66
signals are - move the boat to allow an
unobstructed
antenna
- please contact the Service
Centre to ask for the software
update by SD card
- adjust the SKEW by following
the instructions on page 52
- refer to the user manual of the
receiver for support, spare
parts and warranty conditions.
- remove
deposits from the radome with
a fresh water jet (not under
pressure)
- periodically
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
receiver for support
signal is - move
obstacles obstructing the sat-
ellite signal
- contact the Service Centre
S
WARNING
Do not ship the antenna to GLOMEX for repairs
without having received a corresponding authoriza-
tion to return the material (RMA), as reported in the
general warranty/support conditions.
NOTE: to remove the antenna from the boat,
loosen the 2 screws found on each fastening foot
and lift the antenna from the lower radome.
The feet remain glued to the boat for a subsequent
new installation.
view for the
the condensate
apply a liquid
away from possible
www.glomex.it